Assembly - Healthrider 8.5ex Crosstrainer Elliptical User Manual

ASSEMBLY

To hire an authorized service technician to assemble the elliptical exerciser, call 1-800-445-2480.
Assembly requires two persons. Place all parts of the elliptical exerciser in a cleared area and remove the
packing materials. Do not dispose of the packing materials until assembly is completed. In addition to the
included hex keys, assembly requires a phillips screwdriver
wrench , and a rubber mallet
As you assemble the elliptical exerciser, use the drawings below to identify small parts. The number in parenthe-
ses below each drawing is the key number of the part, from the PART LIST near the end of this manual. The
number following the parentheses is the quantity needed for assembly. Note: Some small parts may have
been preassembled. If a part is not in the hardware kit, check to see if it has been preassembled.
Star Washer M4 x 13mm
(100)–3 Washer (93)–2
M10 x 20mm x M10 x 20mm x
1mm Washer 1.5mm Washer
(81)–2 (84)–2
M4 x 16mm M4 x 16mm
Self-tapping Screw (86)–8
Screw (79)–16
M8 x 75mm Button
Screw (107)–4
M10 x 62mm Bolt (89)–2
M6 Split M8 x 15mm x 4.5mm
Washer (88)–8
Washer (99)–4
M10 x 20mm x M10 x 25mm
2mm Washer Washer (94)–4
(92)–4
M6 x 35mm Phillips
Screw (87)–8
5
, an adjustable
.
M8 Split
Washer (72)–4
M8 Nylon
Locknut (96)–4
M8 x 42mm Bolt
(71)–4
M10 x 20mm Button
Screw (91)–4
M10 x 78mm Button Screw (90)–2
Wave Washer
(98)–8
M10 Nylon
Locknut (97)–2
M8 x 16mm Button
Screw (95)–3
M10 x 23mm Shoulder
Screw (80)–8