Installing The Package From The Command-Line Interface - Nokia NPS6113000 - Secure Access System Getting Started Manual

Installing the Package From the Command-Line Interface

Disable any other packages, including firewall and VPN packages before you install the Nokia
Secure Access System package. This section describes how to install and enable the Nokia
Secure Access System package from the Command-Line Interface (CLI).
You can install the package from the CLI by using the newpkg command. The newpkg
command automatically extracts the package files into the /opt directory and activates the
package. When you enter newpkg, the script guides you through the installation process. You
can also specify command options, which are listed in
Note
Installing or upgrading the package by using the Nokia IPSO clish command is not
supported.
To access the CLI
1. Log on to the appliance by using a command-line connection (SSH, console, or Telnet) over
a TCP/IP network.
For example:
telnet 10.5.189.21
2. Sign on by using the username admin, and use the admin password.
To install the package from the CLI
1. From the command line, enter:
newpkg -n/opt/packages/nsas_3_0_0_<timestamp>.tgz
The following options appear:
Load new package from:
1. Install from CD-ROM.
2. Install from anonymous FTP server.
3. Install from FTP server with username and password.
4. Install from local filesystem.
5. Exit new package installation.
2. Enter
The following response appears:
End of new package installation
cleaning up ..done
Nokia Secure Access System Getting Started Guide
4.
If the Network Voyager ports listed are different from 80 or 443, the Nokia Secure
Access System package is installed, activated, and enabled. See
Gateway as the Administrator"
If you use the i argument with the newpkg command, you must activate the package.
-
See "Activating the Package with Nokia Network Voyager"
Installing the Nokia Secure Access Package
Table 3
on page 27.
on page 26.
"Signing On to the
on page 22.
25