Installing The License - Nokia NPS6113000 - Secure Access System Getting Started Manual

Installing the License

This section describes how to install and configure the gateway license.You can use the
Configure License page to install the license, upload a new license or view the current license.
Upon initial installation of the Nokia Secure Access System, no license file is present on the
gateway. If you do not have a license file, contact your Nokia sales representative or visit the
Nokia License Center either at
Configure License page.
The License Center needs the following information:
License Authentication Code (LAC)
Host Identifier number—appears as the Host Identifier on the Configure License page and
matches the serial number located on the Nokia Secure Access gateway.
Use the LAC and Host Identifier number to generate the license from the Nokia License Center.
When you submit a purchase order to Nokia or your reseller for Nokia Secure Access System,
the hardware is shipped from the factory. A License Authentication Code (LAC) is emailed to
the email address on the purchase order and is usually received before the hardware.
To generate the license from the Nokia License Center
1. From the configuration menu, choose General > License.
From the Configure License page, copy the host identifier number to a clipboard, or write it
down, because you need it in this procedure.
Note
The license generated with the LAC applies only to that hardware serial number and the
license generated can only be used on that appliance.
2. From the Configure License page, click the License Center link
license.
The Nokia License Center page opens.
Nokia Secure Access System Getting Started Guide
Configuring Nokia Secure Access System
https://support.nokia.com/license or choose a link from the
https://support.nokia.com/
33