Table of Contents
Advertisement
Inserting / removing the battery to / from the
camera
Inserting the battery
OFF
1. Set the main switch (1.15) to
.
2. Slide the battery (C) as far as possible into the battery bay,
contacts first and with the positioning groove (1.40) pointing
towards the center of the camera. It automatically engages in
this position.
Removing the battery
1. Set the main switch (1.15) to
OFF
.
2. Turn the release lever 1.36 clockwise as far as it will go.
A spring in the battery compartment then pushes the battery
out by approximately 1cm.
Note:
The locking mechanism has a catch to prevent the battery from
accidentally falling out, even if the camera is held upright.
3. Press the battery back in by around 1mm to release the lock,
and
4. Remove it from the bay or, if the camera is held upright, allow
it to fall out.
Charge level displays (3.2)
The charge level of the battery is indicated in eight stages in the
top panel display (1.11).
= approx. 100%,
White
= approx. 90%,
White
= approx. 75%,
White
= approx. 50%,
White
= approx. 25%,
White
= approx. 10%,
White
= approx.
5%,
Red
= approx.
3%,
Flashing red, replacement or rechar-
ging necessary
Inserting / removing the battery to / from the camera / Inserting and removing the memory cards/ 17
Inserting and removing the memory cards
The LEICA S2 enables you to use 2 card types simultaneously
to store your picture data, and has card slots for SD/SDHC
(Secure Digital) and CF (Compact Flash) cards.
SD/SDHC cards have a write-protection switch that can be
used to prevent unintentional storage and deletion of pictures.
This switch takes the form of a slider on the non-beveled side of
the card; in the lower position, marked LOCK, the data on the
card is protected.
Note:
Do not touch the memory card contacts.
Inserting
1. Set the main switch (1.15) to
OFF
.
2. Open the door (1.25) on the right-hand side of the camera by
sliding it slightly backwards in the direction of the arrow and
then opening it to the right.
Advertisement
Table of Contents
