Selecting The Total Reset Option; Table 15: Total Reset Menu - Kramer VS-3232A User Manual

9.9 Selecting the TOTAL RESET Option

The TOTAL RESET options require you to press the blinking TAKE button
twice for double confirmation.
menu options:
Press: To select:
1 All outputs OFF, to
disconnect all the outputs
2 Factory default, to the
factory default state
In both cases (above), the system status and the volume control stages are set
as follows:
• The gain level of all the input and output channels is set to 0dB
• The audio switching method is set to fade out-in (clean switching)
• The SYNC configuration is set to GENLOCK OFF- immediate switching
• All the interfaces are set to ON
• The interface Reply is set to Reply
• The interface protocol is set to Hex Kramer 2000
• The default setup is set to the Factory default
44
The MENU Commands
Table 15

Table 15: Total Reset Menu

After the change, the LCD displays:
MATRIX erased – all outputs set to OFF
•
OUT 1 is connected to IN 1, OUT 2 is connected to IN
2 ... OUT 31 is connected to IN 31 and OUT 32 is
connected to IN 32
summarizes the TOTAL RESET
KRAMER: SIMPLE CREATIVE TECHNOLOGY