Setting Ethertalk; Ethertalk Enable/Disable - Oki OKIPAGE 12i User Manual

10 base-t ethernet network adapter card

Hide thumbs Also See for OKIPAGE 12i:

Table of Contents

4.2.4

Setting EtherTalk

To use this network card in the EtherTalk environment, EtherTalk must be

set to ENABLE on the printer's operator panel.

1 Confirm that the printer is in the idle state from the LCD panel

and the lamp.

2 Press "ON-LINE" button to set the printer to OFF-LINE, and hold

"MENU1" button for 2 seconds or longer to display "PRINT

MODE".

3 Press "MENU1" button repeatedly to display "NETWORK". After

"NETWROK" is displayed, press "ENTER" button.

4 "TCP/IP" is displayed. Press "MENU1" button repeatedly to move

to "ETHERTALK" Item.

5 When you see that the bottom column of the LCD of the

"ETHERTALK " is "ENABLE*" (* indicates that that value is set),

press "ON-LINE" button without doing anything and exit the menu.

If the bottom column of the LCD is "DISABLE*", press "t" button or "s"

button, to have "ENABLE" displayed in the LCD bottom column. Then

press the "ENTER" button to have "ENABLE*" displayed. Then, press

"ON-LINE" button to exit the menu. Now the ETHERTALK is enabled.

4. ADMINISTRATING PRINTERS NETWORK

Table of Contents