10 Base-T Ethernet network adapter card
5 When you see that the bottom column of the LCD is "DISABLE*",
press "t" button or "s" button until "ENABLE" is displayed in
the LCD bottom column. Then press "ENTER" button to have
the "ENABLE*" displayed. Then, press "ON-LINE" button to end
the menu setting.
6 If you do not wish to receive print data from the network, set
"NETWORK" to "DISABLE*" in the above procedure.
4.2.2
Setting TCP/IP
To use this network card in the TCP/IP protocol, TCP/IP must be set to
ENABLE on the printer's operator panel.
4.2.2.1 TCP/IP Enable/Disable
1 Confirm that the printer is in the idle state from the LCD panel
and the lamp.
2 Press "ON-LINE" button to set the printer to OFF-LINE, and hold
the "MENU1" button for 2 seconds or longer, to have "PRINT
MODE" displayed.
3 Press the "MENU1" button repeatedly, to have the "NETWORK"
displayed, and press the "ENTER" button.
4 When you see that the bottom column of the LCD of "TCP/IP" is
"ENABLE*", press "MENU1" button to proceed to set "IP BYTE1".
If the bottom column of the LCD is "DISABLE*", press "t" button
or "s" button until "ENABLE" is displayed in the LCD bottom
column. Then press the "ENTER" button to have "ENABLE*"
displayed (* indicates that that value is set.)
4.2.2.2 Setting IP Address
1 Following the procedure of the sub-section 4.2.2.1, "TCP/IP En-
able/Disable", press "MENU1" button, to have "IP BYTE1" dis-
played.
2 Change the address by pressing "t" button or "s" button. (If
you hold the button for a several seconds, it will expedite the
address updating.) When the value to be set is displayed, press
the Enter key to finalize it.
3 Press "MENU1" button to move to "IP BYTE2" setting. Set up to
and including "IP BYTE4", in the similar manner to the "IP BYTE1".
62