4.2.2.3 Setting SUBNET MASK
1 Following the procedure of the sub-section 4.2.2.2, "Setting IP
Address", press "MENU1" button, to display "SM BYTE1".
2 Change the address by pressing "t" button or "s" button. (If
you hold the button for a several seconds, it will expedite the
address updating.) When the value to be set is displayed, press
the Enter key to finalize it.
3 Press "MENU1" button to move to "SM BYTE2" setting. Set up
to and including "SM BYTE4", in the similar manner to the "SM
BYTE1".
4.2.2.4 Setting GATEWAY Address
1 Following the procedure of the sub-section 4.2.2.3, "Setting
IPSUBNET MASK", press "MENU1" button, to display "GW
BYTE1".
2 Change the address by pressing "t" button or "s" button. (If
you hold the button for a several seconds, it will expedite the
address updating.) When the value to be set is displayed, press
the Enter key to finalize it.
3 Press "MENU1" button to move to "GW BYTE2" setting. Set up
to and including "GW BYTE4", in the similar manner to the "GW
BYTE1".
4 After setting "GW BYTE4", press "ON-LINE" button. It will en-
able data to be received in TCP/IP. To set NetWare ENABISABLE
right after this, press "MENU1" button after "GW BYTE4" is set.
4.2.2.5 Confirming the setting
1 Print the menu after completing the setting of each address, to
verify that the setting has been made correctly. Press "ON-LINE"
button to set the printer to OFF-LINE, and hold the " Print Menu "
button for 2 seconds or longer. When "MENU HP PCL6*" is dis-
played, press 'ENTER" button.
2 If the set values printed in the menu print are not correct, set the
values again.
4. ADMINISTRATING PRINTERS NETWORK
63