Paper Size Setting; Message Confirmation Report Options; Isdn G4 Option - Oki OKIFAX 5780 User Manual

Paper size setting

The machine is capable of supporting two different paper settings (when
the 2nd-Tray option is installed).
1'ST Paper Size: Use this function to set the primary size of paper used
in the machine. Speed access No. 25.
2'ND Paper Size: Use this function to set a secondary paper size. Setting
cannot be made unless 2nd-Tray option is installed. Speed access No. 26.

Message confirmation report options

The Message Confirmation Report (MCF) is a very convenient feature,
often used on a daily basis to ensure that faxes were sent or arrived at the
proper destinations. The following functions are for setting MCF param-
eters.
MCF. (Single-Loc): Set in the ON state, a MCF will be printed out auto-
matically for single location transmissions. When set to OFF, no report
will be printed out. Speed access No. 70.
MCF. (Multi-Loc): Set in the ON state, multiple location transmission
MCF's will be printed automatically. When set to OFF, no report will be
printed out. Speed access No. 71.
Image in MCF.: Set in the ON state, a portion of the first page of the fax
transmitted will be printed in the MCF. When set to OFF, no image will
be printed in the report. Speed access No. 72.
Err. Report (MCF.): Set in the ON state, an error report is automatically
printed if a fax communication does not end with the service code 0000
(indicates a successful transaction). When set to OFF, the report is not
printed. Speed access No. 73.

ISDN G4 option

If the machine comes installed with an ISDN G4 board, the following
parameters must be set prior to beginning fax operations. Additionally, the
incorporation of the ISDN board also disables a number of the parameters
set for analogue operations (see comments with those parameters listed).
ISDN Dial Mode: This mode is for setting the overall communication
parameters of the machine when in ISDN mode. Set to G3 mode for
communication with G3 machines and dialling from the keypad. Set to G4
36