Panels (If Present); Onto Hinges - GE Monogram ZICP720 Installation Instructions Manual

Installation Instructions
[_] REMOVEBOTH GRILLEPANELS(if present)
• Remove 3 screws holding the grille panel to the
hinge on each side. Lift grille panel off the hinges.
Discard both grille panels. Retain screws.
Leave hinges in open position.
Do not push hinges back.
GrillePanel
Remove 3 Screws
[_ INSTALLGRILLEPANELONTO HINGES
• Place the new unified grille panel over the hinges,
matching screw hole locations.
• Install 3 screws through each hinge and
into the bracket.
• Grasp panel at the center and pull down to close.
NOTE: Check alignment of grille panel to the top of
the doors. To adjust, loosen bracket hinge screws
on all/4 hinges. Adjust and tighten screws.
Install3 Screws
GrillePanel
13