GE Monogram ZICP720 Installation Instructions Manual page 14

Installation Instructions
[_ ADJUST DOORSWING
NOTE: This refrigerator has a 2-position door stop.
When space does not allow the door to swing open
fullg to !]0 °, gou mag change the door swing to
a 90 ° opening. Skip this step if door opening is
satisfactory for your installation situation.
L
GrilleBaseWrap I_
• Lift the grille panel to access the wire cover trim.
• Remove screws on both sides of the wire cover
trim and lift off.
• Use pliers to unscrew door stop and reinstall into
the 90 ° position. PinLocation
asShipped
For130 °
DoorSwing
[_ CHECKAND CORRECTDOORALIGNMENT
• Close the grille panel and both doors.
• Check to be sure the unit is level.
See Step 7 to level the unit.
• Check that the freezer drawers and bottom of doors
are horizontal and even at the lower inside corners.
• Carefully measure the inside corners to determine
if an adjustment is needed. A difference of 1/32" is
acceptable and does not require adjustment.
SKIP THIS STEP IF DOORS ARE LEVEL.
IMPORTANT: If the doors are not evenlg aligned,
theg must be removed and spacers must be installed
to raise or lower one or both doors.
Spacer
Location
\
II
Spacer
Location
/
14