GE Monogram ZICP720 Installation Instructions Manual page 16

Installation Instructions
I_1 CHECKAND CORRECTDOORALIGNMENT (cont.)
Remove
3 Screws
1. Open the grille panel. Remove the grille base wrap.
2. Remove ] screws on the hinge plate.
3. Use pliers to remove door stop pin.
Liftoff andreplace
plasticspacer
4. Lift door off bottom hinge pin. Place the door on a
protected surface; be careful not to damage the door.
5. Remove the original plastic spacer.
6. Place the selected spacer over the hinge.
7. Reverse all steps to replace the door.
[] CONNECTWATERSUPPLY
Connect both refrigerators to the water supplg. _
• Locate and bring tubing to the front of the cabinet.
Turn the water on to flush debris from line. Run
about a quartof water through tubingintoa
bucket, then shut offwater.
Copper Tubing:
Slip a !/4" nut and ferrule (provided) over both
ends of the copper tubing. Insert tube into the
union fitting on the unit and tighten nut to union.
Turn on the water to check for leaks.
GE SmartConnect T"Tubing:
Insert the molded end of the tubing into the
refrigerator connection. Tighten the compression
nut until it is just hand tight.
• Tighten one additional turn with a wrench.
Overtightening can cause leaks!
Turn on the water to check for leaks.
NOTE: Hake sure excess tubing length does not
interfere with drawer closing or toekick installation.
16