Table of Contents
Advertisement
Wireless LAN
2
Click (A) and click [Wireless On].
If [Wireless On] is displayed, skip this step.
3
Click [Add] (B) in [Profiles].
4
Enter the profile name and Wireless network name (SSID), and make
other necessary changes; then click [Next].
5
Make necessary changes and click [OK].
For security, we recommend that you enable encryption (WEP/AES/TKIP). If
you enable encryption, enable encryption on the access point side as well. (The
setting described below is only an example. For the other settings, ask your
system administrator or the person in charge of the network.)
Select [WEP] on [Data Encryption].
A
Select [64-bit] or [128-bit] from [Encryption Level].
B
Input the Encryption key in [Wireless Security Password (Encryption Key)]
C
In the case of pass phrase: [64-bit (5 characters)] [128-bit (13 characters)].
In the case of hexadecimal: [64-bit (10 digits)] [128-bit (26 digits)].
• Set the same values for the computer side and the access point side.
• When using an access point for which "128-bit" can be set (some access
points display "104-bit"), we recommend setting data encryption to "128-
bit" to prevent unauthorized decryption.
6
Select the profile you have set and click [Connect].
If the setting of the profile that is currently connected is changed, the new
setting will not be enabled until you select the profile and then click [Connect].
134
Advertisement
Table of Contents
