Table of Contents
Advertisement
Available languages
Available languages
30" DUAL FUEL SLIDE-IN RANGE INSTALLATION INSTRUCTIONS
(Models with Sealed Top Burners)
GBI Leveling the Range
MEM Models Equipped with Leveling Device
Level the range after installation in the cutout
opening.
l.
Open the range drawer. The leveling screws control
the height of the rear leg.
2.
Adjust the appliance legs as follows until the
underside of the cooktop (or cooktop glass) surface
is sitting level on the countertop (Figure 11).
a.To adjust the front legs, use a wrench on the
leg base and turn counterclockwise to lower or
clockwise to raise the range.
b.To adjust the rear legs, use a ratchet or
a nutdriver and turn the leveling screws
counterclockwise to lower or clockwise to raise
the range.
3.
Check if the range is level by installing an oven rack
in the center of the oven and placing a level on the
rack (Figure 12).
4.
Take 2 readings with the level placed diagonally in
one direction and then the other. Level the range, if
necessary, by adjusting the leveling legs.
5.
If the range cannot be level, contact a carpenter to
correct sagging or sloping floor.
Use this Screw
to Adjust Rear Leveling
Device Height
Screw"
a>
LOWER
<s
RAISE
Figure 11
EIP™|) Models Equipped with Leveling Legs
Level the range and set cooktop height before
installation in the cut-out opening.
1.
Install an oven rack in the center of the oven.
2.
Place a level on the rack (see Figure 12). Take 2
readings with the level placed diagonally in one
direction and then the other. Level the range, if
necessary, by adjusting the 4 leg levelers with a
wrench (see Figure 20).
3.
Taking care to not damage the countertop, slide
range into cutout opening and double check for
levelness.
[P) Decorative Rear Trim Installation (if
required)
1 .
Disconnect the power from the range.
2.
Make sure the range is leveled.
3.
Pull range toward you.
4.
Measure the distance between the floor and the
surface underneath the cooktop frame.
5.
Mark that distance on the wall where the decorative
trim will be installed.
6.
Draw a line.
7.
Place the top of the decorative trim under that line.
8.
Using the screws provided fix the decorative trim
into the wall.
9.
Slide the range back into position as far as it will
go and reconnect the power source.
Distance~.
between th
- floor and
the surface
Figure 13
1
Advertisement
Table of Contents
