Connector Board - Toshiba Tecra A2-S316 Maintenance Manual

4.13 Connector Board

4.13 Connector Board
This section describes how to remove and install a connector board with drawings of the
board with parallel port (parallel port type) as an example. The procedure for a connector
board with TV jack is the same.
Removing the Connector Board
The following describes the procedure for removing the Connector Board (See Figure 4-27,
4-28).
1. Remove the DC-IN jack from the slot of the base assembly.
2. Remove the following screws to remove the harness holder.
M2.5x4B THIN BIND
3. Disconnect the USB I/F cable and connector board cable after unlock from the
connector on the system board.
4. Remove the following screws to remove the connector board.
5. Remove the connector board by lifting it.
Satellite A50/TECRA A2 Maintenance Manual (960-478)
M2.5x4B THIN BIND screw
Figure 4-27 Removing Harness Holder
M2x2.8S THIN BIND screw
4 Replacement Procedures
x2
DC-IN Jack
Harness Holder
x1
4-39