Toshiba Tecra A2-S316 Maintenance Manual page 113

3.2 Executing the Diagnostic Test
Select the option you want to execute and press Enter. When you select 1- SYSTEM
TEST, the following message will appear:
SYSTEM TEST NAME
XXXXXXX
SUB-TEST : XX
PASS COUNT: XXXXX
WRITE DATA: XX
ADDRESS
SUB-TEST MENU :
01 - ROM checksum
02 – Dock/UnDock
03 -
04 – Fan ON/OFF
05 - Geyserville
06 - Quick charge
07 - DMI read
08 - DMI write
09 – CPU Thermistor
10 -
11 – System LED
99 - Exit to DIAGNOSTIC TEST MENU
NOTE: The menu displayed by your computer may be slightly different from the one
shown above.
Select the desired subtest number from the subtest menu and press Enter. The following
message will appear:
TEST LOOP
ERROR STOP : YES (or NO)
Use the right and left arrow keys to move the cursor to the desired option.
Selecting YES of TEST LOOP increases the pass counter by one, each time the test cycle ends
and restarts the test cycle.
Selecting NO returns the process to the subtest menu after the test is complete.
Satellite A50/TECRA A2 Maintenance Manual (960-478)
ERROR COUNT: XXXXX
READ DATA
: XXXXXX STATUS
: YES (or NO)
3 Tests and Diagnostics
xxxxxxx DIAGNOSTIC TEST VX.XX
[Ctrl]+[Break] ; test end
[Ctrl]+[C] ; key stop
: XX
: XXX
3-5