Replacing The Processor Module - Dell Vostro 2510 Service Manual

NOTICE: To ensure maximum cooling for the processor, do not touch the heat transfer areas on the processor
thermal-cooling assembly. The oils in your skin can reduce the heat transfer capability of the thermal pads.
NOTICE:
When removing the processor module, pull the module straight up. Be careful not to bend the pins on the
processor module.
7. Lift the processor module from the ZIF socket.

Replacing the Processor Module

CAUTION: Before working inside your computer, read the safety information that shipped with your
computer. For additional safety best practices information, see the Regulatory Compliance Homepage at
www.dell.com/regulatory_compliance.
NOTICE: Do not touch the processor die. Press and hold the processor down on the substrate on which the die is
mounted while turning the cam screw to prevent intermittent contact between the cam screw and processor.
NOTICE: Ensure that the cam lock is in the fully open position before seating the processor module. Seating the
processor module properly in the ZIF socket does not require force. A processor module that is not properly seated can
result in an intermittent connection or permanent damage to the microprocessor and ZIF socket.
NOTE: If you are installing a new processor, you will receive a new thermal-cooling assembly which will include an
affixed thermal pad, or you will receive a new thermal pad along with a tech sheet to illustrate proper installation.
This procedure assumes that you have completed the removal procedure
1. Align the pin-1 corner of the processor module with the pin-1 corner of the ZIF socket, then insert the processor
module.
NOTE:
The pin-1 corner of the processor module has a triangle that aligns with the triangle on the pin-1 corner
of the ZIF socket.
When the processor module is properly seated, all four corners are aligned at the same height. If one or more corners
of the module are higher than the others, the module is not seated properly.
1 ZIF-socket cam screw 2 ZIF socket
3 pin-1 corner
NOTICE:
To avoid damage to the processor, hold the screwdriver so that it is perpendicular to the processor when
Removing the Processor Module.