Removing The Battery Latch Assembly - Dell Vostro 2510 Service Manual

Back to Contents Page
Battery Latch Assembly
Dell™ Vostro™ 2510
Service Manual

Removing the Battery Latch Assembly

Replacing the Battery Latch Assembly
Removing the Battery Latch Assembly
CAUTION: Before working inside your computer, read the safety information that shipped with your
computer. For additional safety best practices information, see the Regulatory Compliance Homepage at
www.dell.com/regulatory_compliance.
1. Follow the instructions in
2. Remove the hard drive (see
3. Remove the WLAN card (see
4. Remove the fan (see
5. Remove the hinge cover (see
6. Remove the keyboard (see
7. Remove the display assembly (see
8. Remove the palm rest (see
9. Disconnect the cable that secures the internal card with Bluetooth® wireless technology to the system board (see
Removing the Card).
10. Remove the optical drive (see
11. Remove the system board (see
12. Remove the M2 x 3-mm screw from the battery release button.
13. Push the alignment bracket to the left to remove and lift the battery latch assembly over the pin.
NOTICE:
The battery-latch assembly spring is not secured to the latch assembly and can be easily misplaced. When
removing the battery latch assembly, place the spring in a secure location until the latch is ready to be reinstalled.
14. Lift the battery latch assembly out of the computer and unhook the battery latch assembly spring.
NOTICE: Before you remove the battery release button, observe the orientation of the button to ensure proper
installation when the button is replaced.
Before Working on Your
Removing the Hard
Removing a WLAN
Removing the Fan).
Removing the Hinge
Removing the Keyboard).
Removing the Display
Removing the Palm
Removing the Optical
Removing the System Board
Computer.
Drive).
Card).
Cover).
Assembly).
Rest).
Drive).
Assembly).