Removing The Palm Rest - Dell Vostro 2510 Service Manual

Back to Contents Page
Palm Rest
Dell™ Vostro™ 2510
Service Manual

Removing the Palm Rest

Replacing the Palm Rest
Removing the Palm Rest
CAUTION: Before working inside your computer, read the safety information that shipped with your
computer. For additional safety best practices information, see the Regulatory Compliance Homepage at
www.dell.com/regulatory_compliance.
1. Follow the instructions in
2. Remove the hard drive cover. See
3. Remove any cards or blanks installed in the ExpressCard slot and the 8-in- 1 card slot.
4. Remove the WLAN card (see
5. Remove the hinge cover (see
6. Remove the keyboard (see
7. Remove the display assembly (see
8. Remove the M2.5 x 5-mm screw labeled with a "P" from the fan.
9. Remove the fourteen M2.5 x 8-mm screws from the bottom of the computer.
NOTE:
The screw locations may vary slightly from the image shown below.
10. Turn the computer over and remove the three M2.5 x 5-mm screws that secure the top of the palm rest.
Before Working on Your
Removing the Hard Drive
Removing a WLAN Card).
Removing the Hinge
Removing the Keyboard).
Removing the Display
Computer.
for an illustration of the hard drive cover.
Cover).
Assembly).