Replacing The Display Assembly - Dell Vostro 2510 Service Manual

1 display cable 2 antenna cables
3 display assembly

Replacing the Display Assembly

CAUTION: Before working inside your computer, read the safety information that shipped with your
computer. For additional safety best practices information, see the Regulatory Compliance Homepage at
www.dell.com/regulatory_compliance.
This procedure assumes that you have completed the removal procedure
1. Align the display hinges with the holes in the base of the computer, then lower the display into place.
NOTICE: Ensure that the display cable and antenna cables are properly routed and secured beneath the plastic tabs
on the palm rest.
2. In sequential order, replace the four M2.5 x 5-mm screws into the base of the display assembly.
3. Route the display cable and antenna cables beneath the plastic tabs on the palm rest.
4. Slide the antenna cables through the hole in the palm rest and the base of the computer.
5. Connect the display cable to the display cable connector on the system board.
6. In sequential order, replace the four M2.5 x 5-mm screws on display hinges.
7. Replace the keyboard (see
8. Replace the hinge cover (see
9. Close the display and turn the computer upside down.
10. Replace the M2.5 x 8-mm screw that attaches the display assembly to one corner of the computer.
Replacing the Keyboard).
Replacing the Hinge Cover).
Removing the Display Assembly.