Removing A Memory Module - Dell Vostro 2510 Service Manual

Back to Contents Page
Memory
Dell™ Vostro™ 2510
Service Manual

Removing a Memory Module

Replacing a Memory Module
Your computer has two user-accessible SODIMM sockets, both accessed from the bottom of the computer.
You can increase your computer memory by installing memory modules on the system board. See "Specifications" in your
Setup and Quick Reference Guide for information on the memory supported by your computer. Install only memory modules
that are intended for your computer.
NOTE: Memory modules purchased from Dell are covered under your computer warranty.
Removing a Memory Module
CAUTION: Before working inside your computer, read the safety information that shipped with your
computer. For additional safety best practices information, see the Regulatory Compliance Homepage at
www.dell.com/regulatory_compliance.
1. Follow the procedures in
2. Turn the computer upside down.
3. Remove the two screws that secure the memory cover, then remove the cover and set it aside. (See
Memory Module for an illustration of the memory cover.)
1 memory cover
NOTICE:
To prevent damage to the memory module connector, do not use tools to spread the memory module
securing clips.
4. Use your fingertips to carefully spread apart the securing clips on each end of the memory module connector until the
memory module pops up.
Before Working on Your
2 screws (2)
Computer.
Removing a