1 display panel 2 display cable connector
3 display cable
Replacing the E5400 Display Cable
CAUTION:
Before you begin the following procedure, follow the safety instructions that shipped with your computer. For additional safety best
practices information, see the Regulatory Compliance Homepage on www.dell.com at: www.dell.com/regulatory_compliance.
NOTE:
This procedure assumes that you have completed the removal procedure first.
1. Connect the display cable to the connector on the back of the display panel.
2. Replace the display panel (see
3. Replace the display inverter (see
4. Replace the display bezel (see
5. Replace the display assembly (see
6. Replace the keyboard (see
7. Replace the hinge cover (see
8. Close the display and turn the computer over.
9. Replace the bottom of the base assembly (see
10. Follow the procedures in
After Working on Your
E5500 Display Assembly
Removing the E5500 Display Assembly
CAUTION:
Before you begin the following procedure, follow the safety instructions that shipped with your computer. For additional safety best
practices information, see the Regulatory Compliance Homepage on www.dell.com at: www.dell.com/regulatory_compliance.
1. Follow the instructions in
Before Working on Your
2. Remove the bottom of the base assembly (see
3. Remove the hinge cover (see
4. Remove the keyboard (see
5. Remove the display cable from the system board by pulling on the blue tab next to the display cable connector.
NOTICE:
Ensure that the display cable and the antenna cables do not get caught beneath the plastic tabs on the palm rest.
Replacing the E5400 Display
Panel).
Replacing the E5400 Display
Replacing the E5400 Display
Bezel).
Replacing the E5400 Display
Replacing the
Keyboard).
Replacing the Hinge
Cover).
Replacing the E5400 Bottom of the Base
Computer.
Computer.
Removing the E5400 Bottom of the Base
Removing the Hinge
Cover).
Removing the
Keyboard).
Inverter).
Assembly).
Assembly).
Assembly).