Dell E5500 - Latitude - Core 2 Duo 2.53 GHz Service Manual page 11

NOTE: The pin-1 corner of the processor module has a triangle that aligns with the triangle on the pin-1 corner of the ZIF socket.
When the processor module is properly seated, all four corners are aligned at the same height. If one or more corners of the module are higher than the
others, the module is not seated properly.
1 ZIF-socket cam screw 2 ZIF socket
3 pin-1 corner
NOTICE: To avoid damage to the processor, hold the screwdriver so that it is perpendicular to the processor when turning the cam screw.
2. Tighten the ZIF socket by turning the cam screw clockwise to secure the processor module to the system board.
3. Replace the processor heat sink (see
4. Replace the fan (see Replacing the
5. Replace the bottom of the base assembly (see
6. Follow the procedures in After Working on Your
Back to Contents Page
Replacing the Processor Heat Sink).
Fan).
Replacing the E5400 Bottom of the Base Assembly
Computer.
or Replacing the E5500 Bottom of the Base Assembly).