NOTE:
This procedure assumes that you have completed the removal procedure first.
1. Replace the four M2.5 x 5-mm screws (two per side) that secure the display hinges to the display cover.
NOTE:
The display hinge panels are labeled L (left) and R (right).
2. Replace the display bezel (see
3. Replace the display assembly (see
4. Replace the keyboard (see
5. Replace the hinge cover (see
6. Close the display and turn the computer over.
7. Replace the bottom of the base assembly (see
8. Follow the procedures in
After Working on Your
E5400 Display Inverter
Removing the E5400 Display Inverter
CAUTION:
Before you begin the following procedure, follow the safety instructions that shipped with your computer. For additional safety best
practices information, see the Regulatory Compliance Homepage on www.dell.com at: www.dell.com/regulatory_compliance.
NOTICE:
Removal of the bezel from the top cover requires extreme care to avoid damage to the bezel.
1. Follow the instructions in
Before Working on Your
2. Remove the hinge cover (see
3. Remove the keyboard (see
4. Remove the display assembly (see
5. Remove the display bezel (see
6. Remove the M2.5 x 5-mm screw from the display inverter.
7. Disconnect the two display inverter connectors.
8. Lift the display inverter out of the display assembly.
1 top cover
2 display inverter connector
3 M2.5 x 5-mm screw (1) 4 display inverter connector
5 display inverter
Replacing the E5500 Display
Bezel).
Replacing the E5400 Display
Replacing the
Keyboard).
Replacing the Hinge
Cover).
Replacing the E5400 Bottom of the Base
Computer.
Computer.
Removing the Hinge
Cover).
Removing the
Keyboard).
Removing the E5400 Display
Removing the E5400 Display
Bezel).
Assembly).
Assembly).
Assembly).