Removalfrom Window - Kenmore 580.74121 Owner's Manual

_t FRONT INSTALLATION
Install the front grille (packed separately) onto the
cabinet as follows:
• Hook upper tabs of front grille into slots on the
cabinet top. (FIG. 19)
• Push front gdlle's tips towards the cabinet in order
to snap side tabs into the cabinet. (FIG. 19)
• Open the inlet grille. (FIG. 20)
• Install the screw (ITEM E) through the front grille.
(Fig. 20)
• Close filter door. (Fig. 21)
Front Installation FIG. 19
_rille
Front Installation FIG. 20
Front Installation FIG. 21
_'] IF AIR CONDITIONER IS BLOCKED BY
STORM WINDOW FRAME
• If storm window presents interference, fasten a 2"
wide wood strip to the inner window sill across the full
width of the sill The wood strip should be thick
enough to raise the height of the window sill so that
the unit can be installed without interference from the
the storm window frame. See FIG. 22.
Top of wood stripshouldbe approximately3/4"
higher than the stormwindowframe to help
condensationto drain properly to the outside.
• Install a second wood strip(approximately6" long by
11/2"wide and same thicknessas first strip) in the
center of the outer sill flush against the backof the
inner sill.Screw the L brackets into thisstdp.
This will raisethe L bracketas shownin FIG. 22.
1 1/2" rain,
WOOD STRIP MOUNTED (38mm)
ON TOP OF INNER SILL _ 3/4"
_ CLgARANCE
_jJlIl-_--
STORM"
_'R IL FBR;Ro_LK_:RS, NSIDE _AAT__ 'NDOw
INNER FRAME
SILL
OUTER
SILL
TSIDE
FIG. 22
REMOVAL FROM WINDOW
• Turn offand unplugthe air conditioner.
• Removethe front ghlle. See HOWTO REMOVE THE
FRONT GRILLE. Refer to page 13.
• Unscrew the side screws that you installed in Step 15.
• Slide the air conditioner out of the cabinet.
BE CAREFUL NOT TO DROP IT. Hold onto it firmly the
whole way eliding it out. Once removed, set it safety out
of the way.
• Removethe L bracket from window frame and the sash
seal from between the windows.
• Unscrew the side curtains from the window frame. Fold
them back to the sidesof the cabinet.
• Remove screws attaching cabinet to inner sill. Be careful
not to let cabinet fall once screws are removed.
• Remove cabinet from window opening.
• Place air conditioner into cabinet. Reinstall side screws
and Front Grille.
• Place unit and all assembly hardware in air conditioner
shipping carton, and store in clean, dry place.
• Air conditioners covered in this manual pose an
excessive weight hazard. Two or more people
are needed to move and install the unit.
To prevent injuryor strain, use properlifting and
carrying techniques when moving unit.
• When handling the air conditioner,be careful to
avoid cuts from sharp metal fins on front and
rear coils.
• Make sure air conditioner does not fall during
removal.
-8-