Time Remaining - Kenmore Electronic three-speed automatic washers Owner's Manual And Installation Instructions

TIME REMAINING
These pads allow you to increase or
decrease the agitation time for any wash
cycle. Minimum and maximum agitation
times vary depending on the cycle
selected (see pages 23-25).
Once a cycle is selected, the agitation
time from the last time the cycle was
used will be displayed and the AGITATE
TIME will glow.
• To increase the time, press MORE
under the TIME REMAINING display.
• To decrease the time, press LESS
under the TIME REMAINING display.
• When a wash cycle is started, the
approximate time for the complete
cycle, including an estimate for drain
times, will appear in the TIME
REMAINING display. The time will
count down to the end of the cycle.
• Once the cycle has started, you cannot
change the cycle time using the TIME
REMAINING adjustment pads.
• If you are using the delay feature,
the hours of delay time will appear in
the TIME REMAINING display until
the delay time is complete (see page
30 for instructions on using the DELAY
feature).
0 AGITATE TIME
[ 'ul
Iii
TIME REMAINING
SET WATER LEVEL CONTROL
This control gives you the flexibility
to save water when washing small
loads.
Your washer ets you select a water
level setting based on the '_ize of your
wash load.
• To change to a higher water level
setting after the washer has started
to agitate, press MORE under the
WATER L_EVEL display.
• For normal loads, start with the
MEDIUM (middle) setting. Adjust
up or down depending on your load.
Clothes should move 1freely and roll
toward the agitator.
NOTE: When you select a water level
below MEDILJM, the washer automati-
cally lowers the agitation speed in order
to provide improved fabric ,care. This
change happens in every cycle except
HEAVY DUTY and EXTRA DELICATE.
91 LARGELOAD
MEDIUM
u
SMALL LOAD
ATER LEVEIL
cJ
26