Kenmore Electronic three-speed automatic washers Owner's Manual And Installation Instructions page 41

Most laundering problems are easily
solved if you understand the cause.
Check these lists for common laundry
and washer problems. If you need
further assistance, see page 48.
Problem Possible Cause Solution
Message Codes
"LF"
(Long Fill)
Inlet hoses are kinked or
clogged.
Water valve screens are not clear.
Straighten inlet hoses.
Clear screens of any foJ_eignmaterial.
"LD" Drain hose is kinked or clogged. Straighten or unplug hose.
(Long Drain)
"FF" Problem with water level Call for service.
(Fill Failure) sensing system.
"OL" Lid is open during drain or spin. Close lid.
(Open Lid)
"PF" Power to washer went off Press an,./pad to clear the display.
(Power Failure) during cycle. Restart the washer from the beginning
of the cycle.
Washer Leaks Household plumbing is leaking. Repair plumbing.
Inlet hoses not tight. Tighten h3ses
(see "INSTALLATION',_ Section D).
Inlet hose washers not Reseat washers.
properly seated. (see "INSTALLATION',' Section D).
Drain hose not properly Clamp drain hose.
clamped or is off. (see "INSTALLATION',' Section C).
Drain is clogged. Remove ¢ rain clogs. Sink, standpipe,
or floor drain must be able to handle
17 gallons of water per minute.
Tub moved forward during Ensure tub is centered before
unloading, causing water to starting washer.
deflect off of tub ring.
Unit not level causing water
to deflect off of tub ring.
Load is unbalanced. Spray
rinses are deflecting off of load.
Washer is overloaded. Fills or
spray rinses are deflecting
off of load.
Ensure front feet are installed and
nuts are tightened. Level washer.
Reset rear legs
(see "INSIALLATION; Section F).
Redistribute the load.
Reduce load size.
41