ZyXEL Communications VWG1312-B10A User Manual page 209

Note: An interface can belong to only one group at a time.
Figure 91 Interface Group Configuration
The following table describes the fields in this screen.
Table 67 Interface Group Configuration
LABEL
Group Name
WAN Interface
used in the
grouping
Grouped LAN
Interfaces
Available LAN
Interfaces
Automatically
Add Clients
With the
following DHCP
Vendor IDs
#
Filter Criteria
WildCard
Support
VMG1312-B10A User's Guide
DESCRIPTION
Enter a name to identify this group. You can enter up to 30 characters. You can use letters,
numbers, hyphens (-) and underscores (_). Spaces are not allowed.
Select the WAN interface this group uses. The group can have up to one PTM interface and
up to one ATM interface.
Select None to not add a WAN interface to this group.
Select one or more LAN interfaces (Ethernet LAN, HPNA or wireless LAN) in the Available
LAN Interfaces list and use the left arrow to move them to the Grouped LAN Interfaces
list to add the interfaces to this group.
To remove a LAN or wireless LAN interface from the Grouped LAN Interfaces, use the
right-facing arrow.
Click Add to identify LAN hosts to add to the interface group by criteria such as the type of
the hardware or firmware. See
This shows the index number of the rule.
This shows the filtering criteria. The LAN interface on which the matched traffic is received
will belong to this group automatically.
This shows if wildcard on DHCP option 60 is enabled.
Section 13.2.2 on page 210
Chapter 13 Interface Group
for more information.
209