CyberPower Paragon OL1000RMXL2U User Manual page 38

Paragon series
Hide thumbs Also See for Paragon OL1000RMXL2U:
Table of Contents

Advertisement

the full purchase price you paid for the Product (purchase receipt showing price paid is
required).
CONNECTED EQUIPMENT GUARANTEE
If you are the Initial Purchaser and the Product is still covered by the Limited Warranty, the
Connected Equipment Guarantee provides protection for damage to equipment connected
to the Product ("Connected Equipment"), subject to certain terms and limitations.
The Connected Equipment Guarantee is not "first dollar" coverage. It is secondary. If you
have any other source of payment for your loss, such as insurance, another warranty, or an
extended warranty or purchase protection plan ("Primary Coverage"), CyberPower' will pay
only to the extent that the Primary Coverage does not cover the loss. CyberPower's
obligation is reduced by any amounts that you are entitled to recover from the Primary
Coverage, whether or not you make a claim for recovery under any applicable Primary
Coverage.
The Limited Warranty does not cover Connected Equipment, but as is explained below, to
be covered under the Connected Equipment Guarantee, the Connected Equipment must
have been damaged due to a failure of the Product. The Connected Equipment must have
been damaged due to a defect in materials or workmanship of the Product.
In the event of damage to the Connected Equipment, your exclusive remedies, and
CyberPower's sole obligations, are as follows for Connected Equipment. If (a) the Product
purchased and owned by you is defective in material or workmanship; (b) the Limited
Warranty requirements have been met (except that the three year limitation of the Limited
Warranty does not limit the Connected Equipment Guarantee, which is for the lifetime of
the Product), and; (c) none of the limitations or exclusions on warranty coverage apply (or
than the three year limit), CyberPower will (as CyberPower elects, as permitted by law),
repair, replace, or pay the Agreed Damage Amount (defined below) for, the item(s) of your
electronic equipment directly and properly connected to the product (the "Connected
Equipment") if that Connected Equipment is (x) damaged by AC power line transients,
spikes, or surges on properly installed, grounded, and code-compliant 120 volt power lines
in the United States and Canada, or by transients, surges or spikes on standard telephone
equipment lines, or Base 10/100T Ethernet lines that are properly installed and connected
(a "Power Disturbance") and (y) is directly plugged into and properly connected to a
CyberPower Product in its original condition which is properly operated when a Power
Disturbance passes through the CyberPower Product and (y.1) exhausts the protection
capacity of the CyberPower Product or (y.2) damages the CyberPower Product. This
provision sets out the only liability of any character of CyberPower for direct, indirect,
special, consequential, and/or incidental damages under our Limited Warranty, applies only to
Connected Equipment, and all such Liability is limited to the Agreed Damage Amount.
Making a Connected Equipment Guarantee Claim.
To make a Warranty claim for damage to Connected Equipment under the Connected
Equipment Guarantee, you must do the following:
Limited Warranty and Connected Equipment Guarantee 31

Advertisement

Table of Contents
loading

Table of Contents