Table of Contents
Advertisement
Donot usethe
ice chute as a
handle
when
removing
or
repmacing
the
ice storage bin.
Surfaces
there
may be sharp,
Do not put fingers
up ice chute°
Surfaces
there
may be sharp°
J
CLEANING THE ICE DISPENSER
Clean the dispenser and ice container at regular intervals,
particularly before you take a vacation or move, or if the ice
dispenser sticks.
1,
Stop ice production by Hfting the wire signaH arm to the "up" or
2,
Remove ice container by Hfting up and out, Empty and
carefully dean the container with mild detergent, Rinse with
dear water, Do not use harsh or abrasive cleaners, AHow ice
container to dry compHeteHybefore replacing in the freezer,
3,
Remove ice chips and clean the shelf and chute that supports
the ice container,
4,
Replace the ice container, Lower the wire signal arm on the ice
maker to the "down" or ON position and the ice maker will
resume production,
mMPORTANT:
When removing or repHacJngthe ice bin, do not
rotate the augerin the ice bin, If the auger is accidental ytumed,
you must realign the auger by turning it in 90 ° turns until the ice
bin fits into place with the drive mechanism,
Remove and empty the ice storage bin if:
1
An extended power failure tone hour or longer) causes ice
cubes in the ice storage bin to melt and freeze together and
jam the dispenser mechanism,
2
The ice dispenser is not used frequently, Ice cubes will freeze
together in the bin and jam the dispenser mechanism,
Remove the ice storage bin and shake to loosen the cubes,
NEVER use an ice pick or similar sharp instrument to break up
the ice, This could damage the ice storage bin and dispenser
mechanism,
15
Advertisement
Table of Contents
