Ice Maker And Dispenser Working Principles And Repair - Kenmore 795.71012.010 Service Manual

7. ICE MAKER AND DISPENSER WORKING PRINCIPLES AND REPAIR

7-1 Working Principles
7-1-1 Ice Maker Working Principles
Power Input
Initial Control
Ice Making
Control
Ice Ejection
Control
Water Supply
Control
Test Control
1. Turning the Icemaker stop switch off (O) stops the Icemaking function.
2. Setting the Icemaker switch to OFF and then turning it back on will reset the Icemaker control.
Automatic
Shut off Arm
Level Ice Maker Cube MOLD for "Initial Control"
after power is input.
Wait until the water in the cube MOLD is frozen
after ice maker starts operation.
Check ice bucket is full of ice by rotating ice ejection
motor in normal and reverse direction and eject ice into
the ice bucket if ice bucket is not full.
Conduct "Ice Making Control" after supplying water into the ice maker
cube MOLD by operating water valve.
This is for refrigerator assembly line and service. When "ice making test
switch" is pressed, it operates in the following steps: initial
water supply control steps.
- 21 -
ice ejection
Power
Switch