Tools Required For Assembly - Agri-Fab 45-046 Ower's Manual

asseMBLY INsTruCTIONs

TOOLs reQuIred FOr asseMBLY

(1) Hammer
(2) 7/16" Wrenches
(1) Knife or Scissors
Lay out and identify parts and hardware using the
illustrations on pages 2 and 3.
sTeP 1:
(see FIGure 1)
• Remove pre-assembled 1/4" nylock nuts and spacers
from inside of hopper tubes. Discard spacers once
removed. Set aside 1/4" nylock nuts for use in step 2.
FIGure 1
sTeP 2:
(see FIGure 2)
• Attach the stand tube (C) to the hopper tubes using
two 1/4-20 x 1-1/2 hex bolts (BB), the two pre-
assembled bolts, and four 1/4-20 nylock nuts (FF).
FIGure 2
SPACER
PRE-ASSEMBLED
1/4" NYLOCK NUT
BB
FF
FF
sTeP 3:
(see FIGure 3)
THIS STEP FOR MODEL 45-0471 ONLY
• Apply liquid soap to the inside of the foam grip (II).
Work the soap down the length of the grip to coat
the inside. Slide the grip onto the handle (D) until it is
centered.
hINT: The less soap left in the grip, the sooner the grip
will dry and become snug on the handle.
d
FIGure 3
C
4
II