Tools Required For Assembly - Agri-Fab 45-0329 Owner's Manual

For Agri Fab Discount Parts Call 606-678-9623 or 606-561-4983
ASSEMBLY INSTRUCTIONS

TOOLS REQUIRED FOR ASSEMBLY

(1) Pliers
(2) 7/16" Wrenches
(2) 1/2" Wrenches
(2) 9/16" Wrenches
REMOVAL OF PARTS FROM CARTON
Remove all parts and hardware packages from the car-
ton. Lay out all parts and hardware and identify using the
illustrations on pages 2 and 3.
1. Turn the spreader upside down as shown in figure 1.
FIGURE 1
2. Assemble the two hitch braces to the inside of the
hopper frame using a 1/4" x 1-3/4" hex bolt (B) and
1/4" hex lock nut (F) on each side. DO NOT TIGHTEN
YET. See figure 2.
3. Remove the lock nut from the middle bolt in the
crossover tube and shaft support plate. Leave the
bolt in place. See figure 2.
4. Assemble the hitch tube onto the middle bolt and
secure it with the same lock nut you removed. DO
NOT TIGHTEN YET. See figure 2.
IMPORTANT: The hitch tube must attach to the side of
the crossover tube opposite the shaft support plate.
5. Assemble the two hitch braces to the hitch tube using
a 1/4" x 1-3/4" (B) hex bolt and a 1/4" hex lock nut (F).
DO NOT TIGHTEN YET. See figure 2.
ENGLISH
FIGURE 2
6. Tighten the nuts and bolts fastening the hitch braces
7. Assemble a spacer (Q), a 1-5/8" flat washer (L), a
8. Install a 1/8" x 1-1/2" cotter pin (N) into the hole in the
FIGURE 3
5
www.mymowerparts.com
MIDDLE BOLT
HITCH
TUBE
(B) 1/4" x 1-3/4"
(F) 1/4" HEX
HEX BOLT
LOCK NUT
HITCH BRACE
to the hopper frame and the hitch tube, then tighten
the middle lock nut fastening the hitch tube to the
crossover tube. DO NOT COLLAPSE TUBES WHEN
TIGHTENING.
wheel (air valve facing out) and another 1-5/8" flat
washer (L) onto the end of the axle that has only the
small hole. See figure 3.
axle. See figure 3.
(Q) SPACER
(L) 1-5/8" DIA.
FLAT WASHER
SHAFT
SUPPORT
PLATE
CROSSOVER
TUBE
MIDDLE
LOCK NUT
HITCH BRACE
SMALL HOLE
AIR VALVE
(N) 1/8" x 1-1/2"
COTTER PIN