Table of Contents
Advertisement
For Agri Fab Discount Parts Call 606-678-9623 or 606-561-4983
ASSEmBLY
TOOLS REQuIRED FOR ASSEmBLY
(2) 7/16" Wrenches
(2) 1/2" Wrenches
(2) 3/4" or Adjustable Wrenches
(1) Screwdriver
(1) Pliers
Spike points are sharp. Exercise caution when
handling and working near spike disks.
1. Remove the hardware pack and all individual parts from
the carton. Lay out as shown on pages 2 and 3.
2. Attach a hitch tube to the front hole in the right hand side
of the hopper using a 5/16" x 1-1/2" hex bolt, a 5/16" flat
washer and a 5/16" nylock hex nut. Assemble the bolt
and washer from inside the hopper. Do not tighten yet.
See figure 1.
3. Repeat on the left hand side of the hopper.
(E) 5/16" 1-1/2"
(Q) 5/16" FLAT
HEX BOLT
WASHER
(L) 5/16" NYLOCK HEX NUT
FIGuRE 1
EnGLISH
HITCH TuBE
www.mymowerparts.com
4. Assemble the grip onto the lift handle. See figure 2.
5. On the right side, insert a 5/16" x 1-3/4" hex bolt through
a 5/16" flat washer and then through the rear hole in the
hopper and the hitch tube. Assemble the transport tube
and then the lift handle onto the bolt and secure with
a 5/16" nylock hex nut. Do not tighten yet. See figure
2.
6. Assemble a 5/16" x 1" hex bolt and 5/16" nylock hex nut
to the bottom hole in the transport tube assembly and
the lift handle. Tighten. See figure 2.
LIFT
HAnDLE
(L) 5/16" NYLOCK
HEX NUT
FIGuRE 2
7. On the left side, insert a 5/16" x 1-3/4" hex bolt through
a 5/16" flat washer and then through the rear hole in the
hopper and the hitch tube. Assemble the transport tube
onto the bolt and secure it with a 5/16" nylock hex nut.
Do not tighten yet. See figure 3.
(D) 5/16" x 1-3/4"
HEX BOLT
FIGuRE 3
4
(FF) GRIP
(Q) 5/16"
FLAT WASHER
(D) 5/16" x 1-3/4"
HEX BOLT
(E) 5/16" x 1"
HEX BOLT
TRANSPORT TUBE
(Q) 5/16" FLAT
(L) 5/16" NYLOCK
WASHER
HEX NUT
Advertisement
Table of Contents
