Tools Required For Assembly - Agri-Fab SpeedEPart 45-0463 Owner's Manual

aSSemBLY inSTrucTionS

TooLS required For aSSemBLY

(1) Hammer
(2) 7/16" Wrenches
(2) 1/2" Wrenches
Lay out and identify parts and hardware using the
illustrations on pages 2 and 3.
STep 1:
(See Figure 1)
• Remove pre-assembled 1/4" nylock nuts and spacers
from inside of hopper tubes. Discard spacers once
removed. Set aside 1/4" nylock nuts for use in step 2.
SPACER
PRE-ASSEMBLED
1/4" NYLOCK NUT
Figure 1
4
STep 2:
(See Figure 2)
• Attach the RH hitch support tube (2) and LH hitch
support tube (3) to the inside of the hopper tubes using
pre-assembled bolts, two 1/4" x 1-1/2" hex bolts (12),
and four 1/4" nylock nuts (16). do not tighten yet.
STep 3:
(See Figure 3)
• Press a tube plug (25) into the hitch tube (5).
• Assemble the back holes in the hitch tube (5) to the
hitch support tubes using two 1/4 x 2" hex bolts (56)
and 1/4" nylock nuts (16). Tighten all nuts and bolts
assembled up to this point.
16
Figure 2
25
56
56
16
Figure 3
12
5