Agri-Fab 45-046 Ower's Manual page 5

sTeP 4:
(see FIGure 4)
• Assemble the handle tube (D) to the hopper tubes
using two 5/16 x 3/4 screws (AA) and 5/16" lock
washers (HH).
d
hh
aa
FIGure 4
sTeP 5:
• Insert the ends of the flow control bail (E) into the
handle tube (D), inserting the bent end first. The bail
should pull back freely against the handle.
hh FIGure 5
aa
sTeP 6:
• Insert the end of the cable into the flow control bail (E).
• Attach the flow control assembly (B) using two 1/4-20
nylock nuts (FF).
hINT: If the bolts spin when tightening, pull on the bolts
and turn them until they lock in place. Push in on the flow
control dial to help keep the bolts locked in place while
tightening.
FF
FIGure 6
5
(see FIGure 5)
d
(see FIGure 6)
e
B
e