Tools Required For Assembly - Agri-Fab 45-2142 Owner's Manual

ASSEMBLY INSTRUCTIONS

TOOLS REQUIRED FOR ASSEMBLY

(1) Pliers
(1) Hammer
(2) 7/16" Open or Boxed End Wrenches
1. Remove the spreader, the loose parts and the hard-
ware package from the carton. Lay out parts and
hardware and identify using the illustrations on
pages 2 and 3.
2. With the spreader resting upside down on the top of
the hopper, assemble a spacer and then a 1/2" flat
washer onto each end of the axle. See figure 1.
AXLE
SPACER
1/2" FLAT
WASHER
FIGURE 1
3. Place a wheel onto the end of the axle that has no
cross hole. The long end of the hub goes to the
inside. See figure 2.
4. Place a 1/2" flat washer onto the axle and then
lightly tap a hub cap onto the axle until it is snug
against the washer and wheel hub. See figure 2.
NO CROSS HOLE
WHEEL
FIGURE 2
1/2" FLAT
WASHER
HUB CAP
5. Place a wheel onto the end of the axle that has a
cross hole. The long end of the hub goes to the
inside. See figure 3.
6. Assemble a 5/32" x 2" cotter pin through the notched
wheel hub and the axle. See figure 3.
7. Lightly tap a hub cap onto the axle until it is snug
against the wheel. See figure 3.
CROSS
FIGURE 3
8. Remove the middle 1/4" hex bolt, flat washer and hex
lock nut from the crossover tube. See figure 4.
CROSSOVER
TUBE
1/4" FLAT
WASHER
FIGURE 4
4
5/32" x 2"
COTTER PIN
HOLE
WHEEL
1/4" HEX
BOLT
SHAFT
SUPPORT
PLATE
1/4" HEX
LOCK NUT
HUB CAP