Table of Contents
Advertisement
FEATURES
1
14
5
4
63213
1011
9
12
15
FIG. 22
1. Cabinet
2. Vertical
Air Direction
Louvers
3. Cool Air Discharge
4. Inlet Grille
5. Air Filter
6. Control
Board
7. Power
Cord
8. Evaporator
9. Condenser
10. Compressor
11. Base pan
12. Brace
13. Upper
Guide
14. Curtain
15. Remote
Control
USING THE AIR CONDITIONER
_To
reduce the risk of fire, electric
shock, or injury to persons, read the important
SAFETY instructions
section before operating this
appliance
To begin operating the air conditioner
after
installation,
follow these steps:
1. Plug in the air conditioner.(To prevent electrical
hazards, do not use an extension cord or an
adapter plug.)
2. Set the exhaust vent to the CLOSE position.
3. Set the TEMP Control to the coolest setting.
4. Set the MODE Control at the highest COOL level.
5. Adjust the louver for comfortable
air flow.
6. Once the room has cooled, adjust the TEMP and
MODE control to the setting you find most
comfortable.
NOTE : If the air conditioneris turned off, wait 3
minutes before restarting.This allows pressure
insidethe compressor to equalize. Failure to wait 3
minutesbefore restartingmay cause inefficient
operation.
If you move the TEMP Control to a warmer, then
immediatelybackto a cooler setting, the unit will
shutoff. Wait 3 minutesbefore restarting.
VENT
CONTROL
The Vent Control allows the air conditioner to either
recirculate inside air (CLOSE) or exhaust air to the
outside (OPEN). (FIG. 23)
• The CLOSE position is used when maximum
cooling is desired. It may also be used for air
recirculation
without cooling when the air
conditioner is set in the FAN position.
• The OPEN position removes stale air from the
room and exhausts it to the outside. Fresh air is
drawn into the room through your home's normal
air passages.
• The OPEN or CLOSE position can be used with
any fan selection.
PULL
FIG.
23
-10-
Advertisement
Table of Contents
