Cisco Aironet Wireless LAN Client Installation And Configuration Manual page 41

Chapter 3 Installing the Software
Table 3-7
Variable
ATIMDURATION
SLEEPFORDTIM
LISTENTIME
FASTLISTENTIME
OL-1744-02
Power Management Variables (continued)
Value
Between 0 and less than
the beacon interval
ON (YES)
OFF (NO)
0–0xFFFF
0–0xFFFF
Cisco Aironet Wireless LAN Client Adapters Installation and Configuration Guide for MS-DOS
Driver Keywords and Settings
Description
(Optional)—Specifies the length of time for
ATIMs following a beacon.
Default: 5 Kusec
Constant Awake Mode is 0.
In ad hoc mode, this value must be non-zero if
POWERSAVEMODE is PSP or FASTPSP.
This value is used only when starting a new
network. When joining a network, the value
currently in use is adopted.
(Optional)—Allows the node to sleep through
DTIMs for extra power saving. Broadcast and
multicast traffic might be missed.
Default: OFF
Used only in INFRASTRUCTURE mode
when POWERSAVE mode is PSP or
FASTPSP.
(Optional)—Determines how often to awaken
for beacons.
Default: 200 Kusec (200 ms)
Used only in INFRASTRUCTURE mode
when POWERSAVE mode is PSP or
FASTPSP.
The PC card always awakens to receive
DTIMs when in PSP Mode, unless sleep for
DTIMs is set.
(Optional)—Determines how often to awaken
for beacons.
default: 100 Kusec (100 ms)
Used only in INFRASTRUCTURE mode
when POWERSAVE mode is PSP or
FASTPSP.
The PC Card always awakens to receive
DTIMs when in FASTPSP Mode.
3-11