Adjusting the Stand
Height
The tilt stand is locked at the factory.
Follow the instructions below to adjust the stand height.
1
Press the tip of the metal rod tool until it clicks.
The (spring-loaded) tip of the tool will pop out.
2
Take out the tool and insert it in the socket.
3
Flip the tool up towards "OPEN" to unlock.
Tool
4
Adjust the height of the tilt stand.
14
Adjusting the Stand Height
5
Flip the tool down towards "LOCK" to lock.
Note
For your safety, make sure the tilt stand is locked
after adjusting the stand height.
Socket
6
Push the tool back in the storage hole (in the tilt
stand) until it clicks into place.
The tool will be secured by a hook inside the tilt
stand.
Notes
• Keep the tool in the storage hole, so as not to lose
it.
• The orientation of the tool must be correct. Check
the orientation of the tool when making
adjustments and when replacing it in the storage
hole. If you insert the wrong end of the tool, the
tilt stand will not be locked.
Storage hole
Tool