Adjusting The Height Of The Stand - Sony LMD-2450W Operating Instructions Manual

Adjusting the Height of
the Stand
You can adjust the height of the monitor in four levels
for the LMD-2050W and three levels for the LMD-
2450W by changing the position of the stand attachment
bracket and the arm attachment position. Depending on
the height, you can install the input adaptor with the
stand attached to the monitor.
A and B in the following list indicate the screw holes
shown in the illustrations in steps 2 and 4.
Height of the monitor
Position of the stand
attachment bracket
Arm attachment
position
LMD-2050W 376.7
(14
3)
LMD-2450W –
1)
You can install the input adaptor with the stand attached to the
monitor.
2)
Default setting
3)
You cannot attach the stand in combinations of these positions.
1
Remove the stand attachment bracket following
steps 1 to 5 of "Installing to the Rack" (on page 13).
2
Attach the stand attachment bracket to the A or B
screw holes.
The bracket is attached to the B holes at the factory.
LMD-2050W
A A
B
A
– +
B
A: Screw holes for low position
B: Screw holes for high position
14

Adjusting the Height of the Stand

Unit: mm (inches)
A A B
B A B
1), 2)
403.0 444.1 470.4
7 7 1 5
/ ) (15 / ) (17 / ) (18
8 8 2
1)
430.5 471.6 497.9
5
(17) (18 / ) (19
8
A A
B
A
B
LMD-2450W
A: Screw holes for low position
B: Screw holes for high position
3
Attach the stand attachment bracket with four
screws.
B
Use the screws removed in step 5 of "Installing to
the Rack".
A
4
Attach the arm.
1)
/ )
8
1), 2)
Hang the hook of the bracket for using
5
/ ) the A screw holes.
8
– +
5
Secure the arm with four screws.
Use the screws removed in step 3 of "Installing to
the Rack".
6
Attach the arm cover.
To align the lower part of the LMD-2450W and
LMD-2050W display
Use the A screw holes for the LMD-2450W and the B
screw holes for the LMD-2050W display when you
attach the arm in step 4 above.
A A A A
B B
A A
– +
B B
A A A A
B B B B
A A A A
B B B B
Hang the hook of the
bracket for using the B
screw holes.