Adjusting The Height Of The Stand (Lmd-2451Td) - Sony LMD-2451TD Operating Instructions Manual

User manual (operating instructions - lmd-4251td / lmd-2451td)

Hide thumbs Also See for LMD-2451TD:

Operating instructions manual (43 pages)

Specifications (12 pages)

Brochure (44 pages)

Table Of Contents

Table of Contents

Original version

CAUTION

• When you connect the optional LAN cable of the unit

to peripheral device, use a shielded-type cable to

prevent malfunction due to radiation noise.

• For safety, do not connect the connector for peripheral

device wiring that might have excessive voltage to this

port. Follow the instructions for this port.

• The connection speed may be affected by the network

system. This unit does not guarantee the

communication speed or quality of 10BASE-T/

100BASE-TX.

p SERIAL REMOTE RS-232C connector (D-sub

9-pin, female)

Connect to the RS-232C control connector on external

equipment connected to the monitor. The monitor can

be operated according to control commands sent from

external equipment connected to it.

For details on the pin assignment and factory setting

function assigned to each pin, see page 41.

For details, refer to the Interface Manual for

Programmers (saved in the supplied CD-ROM,

Japanese and English only.)

q DVI-D input connector (DVI-D)

Inputs DVI Rev.1.0 applicable digital RGB signal.

To view the signals of the SXGA and higher resolution

when the DVI input is selected, use the cable within 3 m

(118

inches) in length.

r HD15 input connector (D-sub 15-pin, female)

Inputs an analog RGB video signal (0.7 Vp-p, positive

polarity) and sync signal.

The Plug & Play function corresponds to DDC2B.

Adjusting the Height of

the Stand (LMD-2451TD)

LMD-2451TD comes equipped with a stand.

You can adjust the height of the monitor in three levels

by changing the position of the stand attachment bracket

and the arm attachment position. Depending on the

height, you can install the input adaptor with the stand

attached to the monitor.

A and B in the following list indicate the screw holes

shown in the illustrations in steps 2 and 4.

Height of the monitor

Unit: mm (inches)

Position of the

stand attachment

bracket

Arm attachment

position

1), 2)

LMD-2451TD

–

430.5

471.6

497.9

(17)

(18

)

(19

)

You can install the input adaptor with the stand attached to the

monitor.

Default setting

You cannot attach the stand in combinations of these positions.

Remove the stand attachment bracket (see

page 18).

Attach the stand attachment bracket to the A or B

screw holes.

The bracket is attached to the B holes at the factory.

–

A: Screw holes for low position

B: Screw holes for high position

Attach the stand attachment bracket with four

screws.

Use the screws removed in step 1.

Page 17