Chapter 3
Connecting the Router
Terminal Emulator Settings
Use the following settings for the terminal emulator connection:
•
•
•
•
When the terminal emulator establishes communications, the router prompt is displayed.
For more information on terminal emulation settings, see
for Console Connections.
Connecting a Modem to the Console Port
To connect a modem to the router, follow these steps:
Connect the RJ-45 end of the adapter cable to the Console port on the router as shown in
Step 1
Figure 3-4
Connecting a Modem to the Console Port
Connect the DB-9 end of the console cable to the DB-9 end of the modem adapter.
Step 2
Connect the DB-25 end of the modem adapter to the modem.
Step 3
Make sure that your modem and the router console port are configured for the same transmission speed
Step 4
(up to 115200 b/s is supported) and support mode control with data carrier detect (DCD) and data
terminal ready (DTR).
OL-23125-02
9600 baud
8 data bits, no parity
1 stop bit
No flow control
2
Applying Correct Terminal Emulator Settings
1
3
Cisco 819 Integrated Services Router Hardware Installation Guide
Connecting a Modem to the Console Port
Figure
4
3-4.
3-5