Toshiba G8000 SERIES Installation And Operation Manual page 17

DO NOT transport, move, store, or place the UPS on its side.
Forces due to heavy components inside may damage the UPS.
Avoid vibration or shock exceeding 0.5G.
Failing to observe this precaution may cause damage to the UPS.
DO NOT allow the UPS to suffer shock or impact when
unpacking.
Tools used to remove packaging materials may cause damage to the
UPS.
DO NOT push or pull on the sides of the packaging.or the
UPS to move it. Always use a crane, forklift, or pallet jack for
transporting and positioning the UPS.
Pushing/pulling on the sides of the unit to move it may result in damage
to the UPS. See Figure 4.1 Exterior Handling label.
Do not push or
pull from sides
FORKS
WARNING:
Risk of tipping. For safe handling, lift
G8000 Series Installation and Operation Manual
CAUTION
Fig. 4.1 Exterior Handling label
Do not push or
pull from sides
(4 Ft. Minimum length)
from back and sides only (as shown above)
UPS
BY CRANE :
- Cables should have sufficient rating
and equal length.
- Keep UPS leveled when lifting/lowering
and avoid impacts.
BY FORKLIFT :
- Verify forklift maximum load capacity.
- Ensure that the forks are long enough
to support the UPS and are inserted
properly.
- Do not swing or tilt the UPS when
lifting and/or transporting.
See manual for complete details.
7