Table of Contents
Advertisement
ITEM
Registration Low
Registration Normal
Registration High1
Registration High2
LF Revise (Cut Sheet)
I
NITIALISING MENU SETTINGS
To restore the menu settings to their initial values, carry out the steps below.
NOTE
The values adjusted by the Adjustment menus are not initialised by the
following procedure.
1.
Set the Power Switch to OFF.
2.
Press and hold down the SEL and LOAD/PARK buttons together then set the Power
Switch to ON.
A
TOF
DJUSTING
POSITION
Use the following procedure to set TOF to accord with the reference position (6.35 mm
(0.25 in)). The reference position refers to the first line of the paper i.e. the position to
which the printer feeds the paper when automatically loading the paper.
NOTE
Adjusting of TOF can be done in cut sheet mode or continuous forms mode.
1.
Print out the menu settings of the printer as in
page 26
and confirm that the TOF (in cut sheet mode or continuous forms mode) is
6.35 mm (0.25 in).
2.
Set the Paper Type lever to the required paper type.
3.
When continuous forms are used, place the paper on the Pin Tractor.
For cut sheet mode, do not insert the paper at this stage.
4.
In continuous forms mode, press the LOAD/PARK button.
In cut sheet manual feeding mode, press the LOAD/PARK button and place the paper
on the Paper Tray.
FUNCTION
Adjust the print starting
position on printing in the
reverse direction. (The position
moves to the right or left in 1/
720 in increments.)
Adjust the print starting
position on printing in the
reverse direction. (The position
moves to the right or left in 1/
720 in increments.)
Adjust the print starting
position on printing in the
reverse direction. (The position
moves to the right or left in 1/
720 in increments.)
Adjust the print starting
position on printing in the
reverse direction. (The position
moves to the right or left in 1/
720 in increments.)
Adjust a line feed amount in
cut-paper mode.
Operating instructions > 33
SETTING
-10 – -1
0
+10 – +1
-10 – -1
0
+10 – +1
-10 – -1
0
+10 – +1
-10 – -1
0
+10 – +1
-14 – -1
0
+14 – +1
"Confirming current settings" on
Advertisement
Table of Contents
