Table of Contents
Advertisement
I
NITIALISING MENU SETTINGS
To restore the menu settings to their initial values, carry out the steps below.
NOTE
The values adjusted by the Adjustment menus are not initialised by the
following procedure.
1.
Set the Power Switch to OFF.
2.
Press and hold down the SEL and SHIFT buttons together then set the Power Switch
to ON.
A
TOF
DJUSTING
POSITION
Use the following procedure to set TOF to accord with the reference position (6.35 mm
(0.25 in)). The reference position refers to the first line of the paper i.e. the position to
which the printer feeds the paper when automatically loading the paper.
NOTE
Adjusting of TOF can be done in cut sheet mode or continuous forms mode.
1.
Print out the menu settings of the printer as in
page 26
and confirm that the TOF (in cut sheet mode or continuous forms mode) is
6.35 mm (0.25 in).
2.
Set the Paper Type lever to the required paper type.
3.
When continuous forms are used, place the paper on the Pin Tractor.
For cut sheet mode, do not insert the paper at this stage.
4.
In continuous forms mode, press the FF/LOAD button.
In cut sheet manual feeding mode, press the FF/LOAD button and place the paper on
the Paper Tray.
The paper is taken into the default 6.35 mm (0.25 in) position.
5.
Align the paper with the first print line position as follows:
In off-line mode, press the following buttons to adjust the first printing line:
To feed the paper forward by a small amount, hold down the SHIFT button and press
the FF/LOAD button.
To feed the paper backward by a small amount, hold down the SHIFT button and
press the LF button.
NOTE
The correction range is between 2.12 mm (top of the paper) to 368.3 mm. If
the specified correction is beyond this range, the settings will not be
recognised by the printer.
6.
When the paper is positioned at the required TOF, release the buttons in Step 5
above.
To save this position as the TOF, ensure the printer is off-line and press and hold
down the SHIFT and PARK buttons for 3 seconds.
NOTE
Do not turn the Platen Knob or switch off the printer during the above
procedure.
"Confirming current settings" on
Operating instructions > 33
Hide quick links:
Advertisement
Table of Contents
