Table of Contents
Advertisement
Menu
Serial I/F
i
nitialising Menu settings
To restore the menu settings to their initial values, carry out the steps
below.
NOTE
The values adjusted by the Adjustment menus are not initialised by
the following procedure.
1.
Set the Power Switch to OFF.
2.
Press and hold down the SEL and LF/FF buttons together and
then set the Power Switch to ON.
a
tOf
djusting
pOsitiOn
Use the following procedure to set TOF to accord with the reference
position (23.28 mm (11/12 in)). The reference position refers to the first
line of the paper i.e. the position to which the printer feeds the paper
when automatically loading the paper.
NOTE
Adjusting of TOF can be done in cut sheet mode or continuous
forms mode.
ML1120 Plus/ML1190 Plus User's Guide - Operating instructions > 64
IteM
FunctIon
Baud Rate
Set the transmission
speed of the serial
interface.
DTR Signal
Set whether to switch
the DTR signal of the
serial interface by Select/
Deselect or hold it after
power-on.
Busy Time
Set the minimum time
it takes to switch from
a busy state to a ready
state.
SettIng
9,600 bps
4,800 bps
2,400 bps
1,200 bps
600 bps
300 bps
19,200 bps
ready on Power uP
Ready on Select
0.2 sec
1.0 sec
Advertisement
Table of Contents
