Oki ML5100FB User Manual page 29

ITEM
Auto CR
*IBM PPR only
SI Select Pitch (10CPI)
*IBM PPR/AGM only
SI Select Pitch (12CPI)
*IBM PPR/AGM only
Reset Inhibit
Select Language Set
*EPSON only
Impact Mode
Print Direction Command
Power Saving
Power Save Time
PE Detection
Table Print
Carriage Position when
cut sheet Gap 1
Carriage Position when
cut sheet Gap > 1
Paper width mode
FUNCTION
Select whether to perform auto
CR operation upon receiving a
carriage return command.
Set how to handle an SI
command received in 10 CPI
mode.
Set how to handle an SI
command received in 12 CPI
mode.
Set whether to enable or
disable an initial command.
Set whether to enable or
disable a combination of the
code page setting and the
language setting by menu.
Select print mode on power on.
(This item is referred to on
initialisation only by I-PRIME or
power on but not by an
initialisation command.)
Select the validity of a one-way
print setup command.
Set whether to enable or
disable power save mode.
Set idle time to enter power
save mode.
Select whether to detect paper
end or not.
Set whether to divide a path or
not to print on occasions when
printing by the same headpin
continues for 3 in or more in the
same print block.
Selects the carriage position for
cut sheet paper fed (paper
thickness level 1).
Selects the carriage position for
cut sheet paper fed (paper
thickness level 2 or more).
Selects continuous form paper
width used. Select Mode1 when
≥
using paper 8 inches wide,
Mode2 when using paper >5
but <8 inches wide, and Mode3
when using paper less than <5
inches wide.
Operating instructions > 29
SETTING
Yes
No
15 CPI
17.1 CPI
12 CPI
20 CPI
No
Yes
Combined
Code Page Only
Normal
Quiet
Hi Copy
Valid
Invalid
Enable
Disable
5 min, 10 min, 15 min, 30 min,
60 min
OFF
ON
Standard
Special
Left
Middle
Right
Left
Middle
Right
Mode1
Mode2
Mode3