Initialising Menu Settings - Oki ML1190 User Manual

MenU IteM
Serial I/F Parity
Serial Data 7/8
Bits
Protocol
Diagnostic Test
Baud Rate
DTR Signal
Busy Time
i
NitialisiNg meNu settiNgs
To restore the menu settings to their initial values, carry out the steps
below.
NOTE
The values adjusted by the Adjustment menus are not initialised by
the following procedure.
1.
Set the Power Switch to OFF.
2.
Press and hold down the SEL and LF/FF buttons together and
then set the Power Switch to ON.
ML1120/ML1190 User's Guide - Operating instructions > 64
FUnCtIon
Set parity.
Set serial data length.
Set protocols.
Set/Cancel loop testing of
the serial interface.
Set the transmission
speed of the serial
interface.
Set whether to switch
the DTR signal of the
serial interface by Select/
Deselect or hold it after
power-on.
Set the minimum time it
takes to switch from a busy
state to a ready state.
settInG
none
Odd
Even
Ignore
8 bit
7 bit
DtR
X-ON/X-OFF
DTR & X-ON/X-OFF
no
Yes
9,600 bps
4,800 bps
2,400 bps
1,200 bps
600 bps
300 bps
19,200 bps
Ready on Power UP
Ready on Select
0.2 sec
1.0 sec