Troubleshooting - LIFESTYLER C230 831.287630 Owner's Manual

TROUBLE-SHOOTING AND MAINTENANCE
Inspect and tighten all parts regularly.Outer surfaces of the exercise bike can be cleaned using a damp
cloth and mild, non-abrasive detergent. Keep liquids away from the console.
ELECTRONIC MONITOR
If the LCD display becomes faint, or if the electronic monitor does not function properly, the batteries
should be replaced. See assembly step 6 on page 5 for battery installation instructions.If the monitor
still does not function properly,the sensor wire should be checked. See assembly step 6 on page 5 to
see how the sensor wire should be connected.
8
ADJUSTING THE TENSION BELT
If the tension belt slips as you pedal, the tension belt
_should be tightened. Remove the Pedals (10) (see
assembly step 7 on page 6). Remove the four 1/2"
Phillips Screws (4) from the Neck Shield (37). Remove
the #8 x 1" Screws (15) and the 3/4" Tec Screws (36)
from the Left and Right Side Shields (16, 34). Slide the
Side Shields off the exercise bike. To tighten the tension
belt, turn both of the 3/8" Flange Nuts (18) clockwise
one full turn. Repeat until the tension belt no longer
slips. Reattach the Side Shields, Neck Shield and
Pedals.
CENTERING THE TENSION BRACKET
If a grinding noise is heard as you pedal, the Tension
Bracket (35) should be adjusted. Remove the pedals,
side shields, and neck shield (see ADJUSTING THE
TENSION BELT above). Hold the 3/8" x 16 Nylock Nut
(17) with a wrench. If the Tension Bracket is touching the
right side of the Resistance Disk (22), turn the Tension
Bracket Bolt (52) clockwise untilthe Tension Bracket is
centered. If the Tension Bracket is touching the left side
of the Resistance Disk, turn the Boltcounterclockwise.
Reattach the side shields, neck shield and pedals.
TIGHTENING THE CRANK ARMS
If the crank arms become loose, they should be tight-
ened in order to prevent excessive wear. Loosen the hex
nut on the left arm of the Crank (27). Place the end of a
standard screwdriver in one of the grooves in the crank
nut. Lightly tap the screwdriver with a hammer to turn the
crank nut counterclockwise, untilthe crank arms are no
longer loose. Do not overtlghten the crank nut. When
the crank nut is properly tightened, tighten the hex nut.
52 17
TopView
27
hex